KNOWLEDGE ADDA

Which of the following is the most likely reason for large overshoot in a control system?

Email This BlogThis!Share to Twitter Share to Facebook Share to Pinterest

Labels: Control System, ESE 2008, ISE 2008, ISRO Scientist C SC-2014, RPSC Lecturer Technical Education Department Exam 2011

1 comment:

Baldev ChoudharySeptember 8, 2014 at 8:56 PM
Answer - High Positive correcting Torque
ReplyDelete
Replies

Newer Post Older Post Home

Subscribe to: Post Comments (Atom)

Popular Posts

Calculation of Electrical Maximum Demand (Contract Demand)
A long transmission line has considerable ……………….. effect.
(RPSC) RAS Pre 2013 Question and Answer - 4
ESE 2011 General Ability Paper UPSC -61
NEUTRAL GROUNDING RESISTOR AND FAIL SAFE RELAY
When the power trnsferred to the load is maximum, the efficiency of power transfer is
(RPSC) RAS Pre 2013 Question and Answer
Two resistors R1 and R2 give combined resistance of 4.5 ohm when in series and 1 ohm when in parallel the resistance are
(RPSC) RAS Pre 2013 Question and Answer - 3
Millman's theorem yields equivalent

Categories

Followers

Visitor Number

Simple theme. Powered by Blogger.